CCNA Cisco Certified Network Associate (#182)

Section: Version 2.0

Instructions: - Enter IOS commands on the device to verify network operation and answer the multiple questions. - THIS TASK DOES NOT REQUIRE DEVICE CONFIGURATION. - Click the device icon to gain access to the console device of the router. No console or enable passwords are required. - To access the multiple-choice questions, click the numbered boxes on the left of the top panel. - there are four multiple-choice questions with this task. Be sure to answer all four questions before clicking Next button. Scenario:

Refer to the topology. Your company has connected the routers R1, R2, and R3 with serial links. R2 and R3 are connected to the switches SW1 and SW2, respectively. SW1 and SW2 are also connected to the routers R4 and R5. The EIGRP routing protocol is configured. You are required to troubleshoot and resolve the EIGRP issues between the various routers. Use the appropriate

show

commands to troubleshoot the issues.

Study the following output taken on R1: R1#Ping 10.5.5.55 source 10.1.1.1 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 10.5.5.55, timeout is 2 seconds: Packet sent with a source address of 10.1.1.1 ….. Success rate is 0 percent (0/5) Why are the pings failing?

The network statement is missing on R5.
The loopback interface is shut down on R5.
The network statement is missing on R1.
The IP address that is configured on the Lo1 interface on R5 is incorrect.