CCNA Cisco Certified Network Associate (#910)

Section: Version 2.0

Instructions: - Enter IOS commands on the device to verify network operation and answer the multiple questions. - THIS TASK DOES NOT REQUIRE DEVICE CONFIGURATION. - Click the device icon to gain access to the console device of the router. No console or enable passwords are required. - To access the multiple-choice questions, click the numbered boxes on the left of the top panel. - there are four multiple-choice questions with this task. Be sure to answer all four questions before clicking Next button. Scenario:

Refer to the topology. Your company has connected the routers R1, R2, and R3 with serial links. R2 and R3 are connected to the switches SW1 and SW2, respectively. SW1 and SW2 are also connected to the routers R4 and R5. The EIGRP routing protocol is configured. You are required to troubleshoot and resolve the EIGRP issues between the various routers. Use the appropriate

show

commands to troubleshoot the issues.

The loopback interfaces on R4 with the IP addresses of 10.4.4.4/32, 10.4.4.5/32 and 10.4.4.6/32 are not appearing in the routing table of R5. Why are the interfaces missing?

The interfaces are shutdown, so they are not being advertised.
R4 has been incorrectly configured to be in another AS, so it does not peer with R5.
Automatic summarization is enabled, so only the 10.0.0.0 network is displayed.
The loopback addresses haven’t been advertised, and the
network
command is missing on R4.