CCNA Cisco Certified Network Associate (#112)

Section: Version 3.0

Instructions

Enter IOS commands on the device to verify network operation and answer the multiple-choice questions.

THIS TASK DOES NOT REQUIRE DEVICE CONFIGURATION.

Click the device icon to gain access to the console of the device. No console or enable passwords are required. To access the multiple-choice questions, click the numbered boxes on the left of the top panel. There are four multiple-choice questions with this task. Be sure to answer all four questions before clicking Next button.

Scenario

You are a junior network engineer for a financial company, and the main office network is experiencing network issues. Troubleshoot the network issues. Router R1 connects the main office to the Internet, and routers R2 and R3 are internal routers. NAT is enabled on router R1. The routing protocol that is enabled between routers R1, R2 and R3 is RIPv2. R1 sends the default route into RIPv2 for the internal routers to forward Internet traffic to R1. You have console access on R1, R2 and R3 devices. Use only show commands to troubleshoot the issues.

The R1 clock is synchronized with the ISP router. R2 is supposed to receive NTP updates from R1. But you observe that the R2 clock is not synchronized with R1. What is the reason R2 is not receiving NTP updates from R1?

The IP address that is used in the NTP configuration on R2 router is incorrect.
The NTP server command not configured on R2.
The R2 router Ethernet interface that is connected to R1 is placed in shutdown condition.
The R1 router Ethernet interface that is connected to R2 is placed in shutdown condition.