Implementing Cisco IP Switched Networks (SWITCH v2-0) (#389)

Instructions:

Enter IOS commands on the device to verify network operation and answer the multiple-choice questions.

THIS TASK DOES NOT REQUIRE DEVICE CONFIGURATION.

Click on R1 and R2 to gain access to the consoles of these devices. No console or enable passwords are required.

To access the multiple-choice questions, click on the numbered boxes on the left of the top panel.

There are

four

multiple-choice questions with this task. Be sure to answer all four questions before selecting the Next button

Scenario: Your customer has asked you to come in and verify the operation of routers R1 and R2 which are configured to use HSRP. They have questions about how these two devices will perform in the event of a device failure. Click on the devices or the tabs at the bottom of the screens to access the CLI to answer their questions.

Refer to the exhibit. If router R1 interface Etherne0/0 goes down and recovers, which of the statement regarding HSRP priority is true?

The interface will have the priority decremented by 40 for HSRP group 1.
The interface will have the priority decremented by 60 for HSRP group 1
The interface will have its current priority incremented by 40 for HSRP group 1
The interface will have its current priority incremented by 60 for HSRP group 1
The interface will default to the a priority of 100 for HSRP group 1